What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 01:11

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
First Sentence:
When you visit a store, do you go to shop or buy?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is 'the assistant's answer'
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Midea is recalling its U-shaped air conditioners because of potential mold growth - The Verge
Here is a simplified AC power diagram.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
a photo is worth a thousand words.
What do porn stars do when they get old?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Barnstars:
It also is a device that limits the change in current flow.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
NASA Discovers Strange X-Shaped Structures in Earth’s Upper Atmosphere - Indian Defence Review
what exactly is a ‘surge’ protector?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
The bolt then partially travels down the line to your home.
Upvotes:
but this device (an Inductor) … impedes the rapid changes in the current.
but I think this circuit , shows a few more pieces.
UNC Botches Lead, Falls to Arizona in Super Regional Rubber Match - 247Sports
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This device then solves the entire problem.
But… the neutral is now “floating” because of the 1 ohm resistance.
Market's Slide Broadens in Afternoon Trading - Barron's
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
How do you get started in bestiality with a dog as a male?
The third is lightning and “how it gets conducted into a home.”
Because the load is inductive, the current lags the voltage.(by a bit).
These devices are installed between the “hot” and “neutral” and protective ground.
Wall Street floods into Bitcoin Futures as CME trader count hits all-time high - AMBCrypto
In schematic diagrams this is the symbol for a fuse:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
How can I handle my distrust and jealousy for my partner?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
He then describes Rainy Season and Lightning.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Why don't I get sleep at nights?
Now when you have a certain ac resistance, then a current flows in a loop.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
A circuit breaker is similar, but is resettable.
This is where the MOV conducts again, and dissipated the energy.
He then describes the function of a fuse.
(Dc diagram shown, AC is similar).
But it can get overloaded, and no longer works.
[image of Common-mode choke]
There are two important concepts here.
What is lightning?
One
The other is “what does a “fuse” do?”
An AC voltage/ current source, and an ac inductive load.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
so, what happens?
This is where this question deviates from being a 'generic' question, and becomes more specific.
For this case there are devices called Metal oxide varistors (MOV).
At least they know the answer if they wanted it.
What does a fuse do?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
[old diagram got deleted by accident]
eight
Edit 2024–10.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
I post the exact comment here.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are three different concepts here that are getting confused.
nine
2024–10–16 [ OO OLAOYE OYEBODE ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then asserts :
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
It seems Mohan does not understand the difference between a comment and an Answer.
One is “what exactly is in a ‘surge protector’ ? ”
The MOV will conduct when the voltage exceeds 50% of line voltage.
At one ohm, the resistor has a maximum of 1 watt power.
These are simplified answers to the original question, and does not change anything I wrote above.
A fuse is a non-resetable over current circuit protector.
This one hit behind the barn.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
the problem then depends on "how fast does the fuse operate?".
2024–10–10[John johnson John Johnson ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”